Product Description

BRIGHT RED LED TOWED CAR WIRING KIT ... BYPASS YOUR CAR'S ELECTRICAL SYSTEM!

LED bulbs and sockets are typically used to wire a towed car for flat towing. They are permanently installed through the backside of the taillight housing. While towing, the LED's perform all turn signal, brake and park light functions at the rear of the towed vehicle.

LED's have significant safety and appearance advantages over incandescent bulbs. They are brighter, activate faster and have a much longer lifespan than incandescent bulbs. They are ideal for dinghy lighting systems because they generate almost no heat and can be used where incandescent bulbs would melt the taillight lens. Also, LED's draw significantly less power. Since the power comes from the front of the RV, the current must push through 40 to 60 feet of wire before hitting the bulbs at the rear of the towed. Because LED's have much lower amperage requirements, they result in vastly brighter taillights when compared to incandescent bulbs.

The LED bulbs illuminate red. This is important. White LED's behind a red lens result in pink colored taillights. Roadmaster specifically uses a bright red LED resulting in highly visible red taillights. The 152-LED is a comprehensive towed vehicle wiring kit. It includes a 25' wiring harness, two electrical pigtails, two sockets, two red LED bulbs, wiring split loom, zip ties, wiring supplies and installation instructions. Sockets fit a 1" diameter hole.

Red LED bulbs for a truly red taillight appearance
Low profile sockets fit the widest range of vehicles
450 Lumens of light output
LED's are brighter, last longer and won't melt your taillight lens
Completely isolates the RV's wiring from the towed vehicle's electrical system
Sockets have the same pin arrangement as an 1157 taillight bulb
Satisfies legal requirements for towed vehicle lighting

This kit comes in a retail packaged clamshell. Roadmaster offers this same kit in a plain brown box, 152-LED. Bulbs and sockets only are part number 152-2. Bulbs only are part number 152-50.

Note: The LED bulb protrudes 1 7/8" from the surface of the mounting hole. Make certain your taillight assembly has sufficient depth to accommodate these bulbs.

WARNING This product can expose you to chemicals including chromium and vinyl chloride, which are known to the State of California to cause cancer and birth defects or reproductive harm. For more information, go to www.P65Warnings.ca.gov.